AQI Sensor for UPPCB — CPCB-Listed PM2.5 & PM10 Monitoring in UP
An AQI sensor for UPPCB has to be a CPCB-listed continuous ambient monitor with a current calibration certificate and a live data feed — not a marketplace dust meter on a pole. We supply, install and integrate PM2.5 and PM10 monitors for construction, RMC and C&D waste sites across Noida, Greater Noida, Ghaziabad, Bulandshahr, Hapur and Meerut.
The Uttar Pradesh Pollution Control Board and CAQM both judge a site's dust performance on data, and data is only defensible when three conditions hold together: the analyser comes from a manufacturer on the CPCB list, its calibration is inside twelve months, and readings are pushed continuously to a dashboard the regulator or your compliance file can reference. Sites in Noida and Ghaziabad frequently satisfy the first condition and fail the other two.
We survey the plot before quoting. The monitor needs a mounting point three to four metres above ground, clear of anti-smog gun spray and truck exhaust, with confirmed mobile coverage at that exact coordinate — a detail that decides whether a sensor reports reliably through a Ghaziabad monsoon or drops offline weekly. Installation includes a weatherproof enclosure, surge protection, dual-operator SIMs and an anti-theft cage.
Commissioning covers configuration of the 15-minute data push, verification that readings are arriving, and handover of the calibration certificate for your inspection file. After that our monitoring desk watches uptime around the clock and dispatches an engineer the same day a unit drops offline, rather than waiting for a regulator to notice the gap.
For builders who need continuous monitoring only for the duration of works, the same CPCB-listed units are available on monthly rental with installation, integration, calibration and de-installation included. And because DPCC, HSPCB and RSPCB accept the same class of instrument, a single specification covers projects in Delhi, Gurugram, Faridabad, Bhiwadi and across UP.
What's included
- ▸CPCB-listed continuous ambient air quality monitor for UPPCB sites
- ▸PM2.5, PM10, NO₂, SO₂, CO plus temperature, humidity and wind
- ▸Live 15-minute data push with dashboard access for your compliance file
- ▸Valid 12-month calibration certificate supplied for inspections
- ▸Installed in Noida, Greater Noida, Ghaziabad, Bulandshahr, Hapur and Meerut
- ▸AQI sensor rental or outright purchase with 24×7 uptime monitoring
Our process
- 01
Requirement call
Plot area, site type and whether you need purchase or monthly rental of the AQI sensor.
- 02
Site survey
Mounting height, power source and network coverage checked so readings hold up during inspection.
- 03
Install & integrate
Sensor mounted, enclosure sealed and continuous data push configured and verified.
- 04
Certificate & AMC
Calibration certificate handed over and AMC activated with same-day field response.
Frequently asked
Which AQI sensor is acceptable for UPPCB compliance?
A continuous ambient air quality monitor from a CPCB-listed manufacturer with a calibration certificate not older than twelve months. We supply only such models and verify live data before handover.
Do Noida and Greater Noida sites need continuous PM monitoring?
Sites in UP's NCR districts fall under CAQM dust-control directions, and mid-to-large C&D projects, RMC plants and C&D waste facilities are expected to run continuous PM2.5/PM10 monitoring. We confirm what applies to your plot during a free assessment.
Can I rent an AQI sensor for a UP project?
Yes. Monthly rental includes installation, integration, calibration and de-installation once the project closes.